Countrywoods & Masterwoods
Whisper & Pleated
Rotate the wand to tilt the slats from fully opened to fully closed or the desired angle.
Raiding and lowering of blind:
To raise, tilt the slats to the fully opened position. Remove the bottom rail from the hold down clips (if fitted. Pull the lift cord towards the centre and raise the blind. To lock in position move the cord towards the outer edge of the blind to engage the cordlock. To lower pull the cord towards the centre of the blind and lower gently.
Open or close the shutter blades by using the control rod or via the blade if control is hidden.
Pulling one of the single cords will tilt the slats in one direction. To raise or lower the blinds, fully open the slats and pull the double cord towards the middle of the blind, out at approx 45° and slightly down. When the blind is at the desired height, return the cord to the side of the blind to engage the cordlock. To tilt slats on ‘Legacy’ blinds use both cords in tandem.
The chain: Controls the tilting of the vertical blind and should be tilted several times to ensure it opens and closes correctly.
The cord: Traverses the blades clear of the window allowing access for opening a window or cleaning. Before traversing the blades ensure they are tilted (open) at 90° to the window.
Chain Control: to raise or lower simply use the chain control
Tracking: If for any reason your Rollershade or Sunscreen fabric starts to roll up unevenly and is in danger of contacting the bracket, the following action should be taken. Roll the shade down to its lower limit, take hold of the bottom rail and guide the fabric back while operating the chain control. For best results perform this action regularly which allows the fabric to retain its new memory.
Your installer will fully explain its operation. If you require any further assistance call us on 0800 10 27 10